Wolf Legacy Dual Fuel Range Message CHECKSUM: self-check failed

What CHECKSUM means

On legacy Wolf DF dual fuel ranges that show text messages, the message CHECKSUM means the control's self-check failed at power-up or when the oven off key was pressed. The control tests its own stored data, and the result did not match. The display shows CHECKSUM and the oven may not heat until the control is checked. Jot down when CHECKSUM began and what you were doing, as that narrows our first checks.

Common causes of CHECKSUM

Stored control data that failed the self-test
Control board memory that is not reading correctly
Power interruption that disturbed the data

✓ One safe check you can try

1. Turn the oven off. 2. Power the range down at the breaker for sixty seconds, then up again. 3. Watch the display at power-up for CHECKSUM. 4. If it appears again, stop using the oven and call us. 5. Note what the display showed and when it began, then give us a call.

! Why to stop there

A failed self-check is a control board matter, and resets do not repair it.
We confirm the cause before replacing a costly board.
Price is given in writing first, with a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

0221Wolf Dual Fuel DFxx50 Code 0221: Bake element DLB relay shorted, right or single oven Ignition LockoutWolf Gas Burner Code Ignition Lockout: Slow-Blinking Call-for-Heat Light 0222Wolf Dual Fuel DFxx50 Code 0222: Bake element DLB relay shorted, left oven LOWER RELAYWolf Legacy Dual Fuel Range Message LOWER RELAY: Shift Register Feedback Failure OPPWolf Legacy Dual Fuel Range Code OPP: Other Oven Locked for Self-Clean PFWolf Legacy Dual Fuel Range Code PF: Power Failure or Too Hot for Mode 01Wolf Legacy Dual Fuel Range Code ERR 01: Door Lock Switches Not Sensed O9Wolf Legacy Dual Fuel Range Code O9: meat probe shorted

CHECKSUMCHECKSUM questions

What does CHECKSUM mean?

It means the control ran a self-check on its stored data and the result was wrong. That can happen at power-up or when you press the oven off key.

Is it caused by a power outage?

A power interruption can disturb the data, and a reset may fix it once. If CHECKSUM keeps showing, the control needs testing. You see the written price first, which keeps the visit short and focused.

Is the oven safe to use?

We would not rely on it. Book a visit and we will give a written price before work. Our technician checks the likely causes in order, and you only pay for what is needed.