Wolf CSO Steam Oven Code F16: Touch control error

What F16 means

F16 on Wolf CSO convection steam ovens, such as the CSO24 and CSO30 series, is the display label for the E136 and E137 touch control codes. In plain terms the touch control did not report in as expected. Owners see F16 and the touch panel may be unresponsive or act strangely. The research entry is brief, so a technician checks the touch panel and its connection to the control.

Common causes of F16

Touch control not responding properly
Touch panel connection to the control

✓ One safe check you can try

1. Wipe the touch panel with a dry, soft cloth. Do not use wet cleaner on the glass. 2. Switch the breaker off for one minute, then back on. 3. Wait for the display to start before touching it. 4. If F16 returns, call us. Do not remove the panel.

! Why to stop there

The panel and its cable are behind the front.
Moisture or cleaner spray near the panel can make things worse.
A diagnosis tells us whether the panel or the control is at issue.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Steam Oven codes

Boiler scaled upWolf Convection Steam Oven Message Boiler scaled up: Descale required E26Wolf Convection Steam Oven Code E26: Climate sensor problem E87Wolf 24-Inch E Series Code E87: Exhaust slide valve jammed or shorted E42Wolf Convection Steam Oven Code E42: Water temperature sensor error E26Wolf 24-inch E Series Code E26: Break or loose contact in climate sensor, or blocked duct E87Wolf Convection Steam Oven Code E87: Exhaust slide valve stuck F6Wolf Convection Steam Oven Code F6: Processor and Main Relay Error E51 F0Wolf Convection Steam Oven Code F0: Core temperature probe sensor problem

F16F16 questions

What is F16?

It is the label for the E136 and E137 touch control conditions on these steam ovens. The touch control is the area we check. On site we look at touch control not responding properly and touch panel connection to the control, then quote the repair in writing.

Can cleaning spray cause it?

It can, if liquid gets under the panel edge. Clean with a barely damp cloth and dry it straight away. Starting point for us is usually touch control not responding properly, with the price written down before any work.

Will a reset clear it?

Sometimes a reset gives the panel a clean start. If F16 comes back, the panel or its connection needs service, and we quote that in writing. We would also rule out touch panel connection to the control before recommending anything.