Wolf Legacy E Series Code Overtemp Error, Door Locked: 11 x 1 relay module

What Overtemp error - door locked means

On Wolf Legacy E Series wall ovens from the SO30TE/PE generation, code 11 x 1 is an overtemp error with the door locked. During a locked-door cycle such as self-clean, the oven went above its allowed temperature. The prescribed correction is to replace the relay module. Airflow advice belongs to the separate 12 0 0 ambient overtemp code, and door-motor advice to 11 x 0, door unlocked.

Common causes of Overtemp error - door locked

Relay module holding heat on
Overtemperature during a locked-door cycle
Temperature control not shutting off

✓ One safe check you can try

1. Switch the oven off, keep the door closed and let it cool for several hours. 2. Turn the breaker off. 3. Do not run self-clean again. 4. Call us for service; the relay module is the part this code points to and is not an owner repair.

! Why to stop there

A locked door during overheating means you cannot simply open it, so be patient.
The relay module carries oven power and sits inside the unit.
We give a written price first and cover the repair with a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 2030Wolf M Series Code 2030: Relay board ambient thermistor circuit 3821Wolf M Series Code 3821: Upper bake bank wiring error 2130Wolf M Series Code 2130: Relay board voltage calibration failed

Overtemp error - door lockedOvertemp error - door locked questions

What does 11 x 1 mean?

It means the oven overheated while the door was locked. The listed correction is to replace the relay module. It is not the same as 11 x 0, which covers the door-unlocked condition.

Should I check airflow or the fan?

Airflow advice belongs to the 12 0 0 ambient overtemp code, not this one. For 11 x 1 the relay module is the focus, so we test it first.

Can I open the door to cool it faster?

The door stays locked until the oven is cool. Do not force it. Leave the oven off, wait, and call us once the latch releases.