Fixing the Wolf CI36560T/S Induction Cooktop
The CI36560T/S puts five induction elements across 36 inches of Transitional trim. It tends to anchor a long counter or an island, with plenty of room for a stockpot on one side and a skillet on the other. After years of daily use, the weak spots are usually the glass-side controls and the sensors under the zones.
One pattern deserves a mention when you call: a problem that wanders from zone to zone rather than sticking to one. That usually points at the cookware, such as a warped base or a pot that is not induction-ready, rather than at a failing zone. It changes where we begin.
If a single zone really is the culprit, we test its coil and sensor directly. Parts follow the 60-generation parts list, so we match them to your rating label. Our price is written and agreed before work starts, and workmanship is covered for 30 days.
A moving problem often traces back to the pan: a bowed base or non-magnetic metal. We test with known-good cookware first. If the issue still wanders, we check power delivery and the control board.
Not the electronics. The trim affects the look at the edge and how the unit sits in the counter. We note it on the work order so any trim-specific parts are matched properly.
In most cases, yes. Because each zone has its own coil and detection, we can often address just that zone. We confirm the parts and give you a written price before beginning.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
