Wolf Legacy E Series Code Error 07 x 16: Left convection relay open

What Error 07 x 16 means

Error 07 x 16 on Wolf Legacy E Series wall ovens, such as the SO30TE/S/TH, means the left convection relay is open. The control calls for the left convection element and the relay does not close, so convection heating is weak and the display shows the code. Which cavity is involved is shown by the digit that stands in for the x.

Common causes of Error 07 x 16

Left convection relay not closing
Relay board output damaged
Connector to the left convection circuit loose

✓ One safe check you can try

1. Shut off the cooking mode and let the oven return to room temperature. 2. Switch to a plain bake setting and see whether the oven heats. 3. Reset the oven power by turning its breaker off for one minute. 4. If Error 07 x 16 remains after the reset, call us and leave the oven off.

! Why to stop there

The left convection relay is on the relay board behind the oven panels.
Relay, element, and wiring problems look alike from outside, so testing comes first.
Our price is in writing before any part is ordered.
Our guarantee on workmanship lasts 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 2A30Wolf M Series Code 2A30: Microprocessor communication failure 1231Wolf M Series Code 1231: Upper bake element DLB open 2C20Wolf M Series Code 2C20: Relay board network failure

Error 07 x 16Error 07 x 16 questions

Is this the same as Error 03 x 3?

They are related. Error 03 x 3 says the left convection element is not detected, while Error 07 x 16 says its relay is open. We check both in one visit.

Is there a right-side version?

Yes, Error 07 x 17 is the right convection relay open. The digit tells us which side to start with. The answer shapes the repair plan.

Will bake mode still work?

Usually yes, because standard bake uses other circuits. Avoid convection until we check the relay, and tell us which cavity showed the code. We would rather confirm than assume.