Wolf 24-inch E Series Code E46: Elevated cavity temperature in pyrolysis phase 2

What E46 means

On Wolf 24-inch E Series wall ovens like the SO24 and SO2450, E46 reports an elevated cavity temperature in phase 2 of a pyrolysis (self-clean) operation. The cavity ran hotter than the control allows during the cleaning cycle, so the oven stops the cycle and shows E46. Expect a locked door and a hot oven for a while afterward. The cycle does not resume on its own.

Common causes of E46

A temperature sensor reading wrong during cleaning
Heavy food residue burning hotter than expected
A heating control that did not switch off in time

✓ One safe check you can try

1. Do not open the door by force. Wait until the oven is fully cool and the latch releases. 2. Wipe out heavy spills and loose debris before the next cycle. 3. Reset the breaker for a minute. 4. Do not rerun pyrolysis. If E46 returns, call us.

! Why to stop there

Overtemperature during cleaning is a safety matter.
We test the sensor and heating control before the next cycle.
A written estimate and our 30-day warranty protect you.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 1831Wolf M Series Code 1831: Upper door lock relay open 3311Wolf M Series Code 3311: Upper thermal cutoff open 1A31Wolf M Series Code 1A31: Upper left convection fan triac open

E46E46 questions

What is pyrolysis phase 2?

It is the hottest stage of the self-clean cycle. E46 means the cavity got hotter than the oven allows during that stage. Phase 2 is the stage when the heat is at its peak.

Why is the door locked?

The latch stays locked while the cavity is very hot. Wait until it cools, and do not try to force it. Forcing it could hurt you or the latch.

Should I run the cleaning again?

No. Let us check first, because the cause could repeat and run the oven too hot. The cause may repeat otherwise. It also lets us explain what we found in plain words.