Wolf Legacy E Series Code Error 07 x 14: Outer bake relay open

What Error 07 x 14 means

Error 07 x 14 on Wolf Legacy E Series wall ovens, including the SO30PE/S/PH, reports that the outer bake relay is open. The control calls for power to the outer bake circuit, and the relay does not close. Baking is weak or absent, and the display holds the code. Where you see an x, the oven prints its cavity digit instead.

Common causes of Error 07 x 14

Outer bake relay not closing
Relay board output damaged
Connector or wire to the relay loose

✓ One safe check you can try

1. Take any food out once it is safe, then turn the oven off and wait. 2. Reset the breaker for one minute and restore power. 3. Try a short bake and check whether heat builds. 4. If the same code returns, which is Error 07 x 14, stop and call us.

! Why to stop there

Relay work happens at line voltage behind the oven panels.
The relay, the element, and the wiring all give a cold oven, so we measure to separate them.
The price is in writing before any repair.
The visit ends with a 30-day workmanship warranty on our work.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 1A31Wolf M Series Code 1A31: Upper left convection fan triac open 3421Wolf M Series Code 3421: Upper door lock timeout 1B21Wolf M Series Code 1B21: Cooling fan triac shorted (1B21)

Error 07 x 14Error 07 x 14 questions

Is this the outer element or the relay?

The code names the relay that feeds the outer bake circuit. The element has its own message, Error 03 x 1, so we know which side to check first.

What is the opposite code?

Error 07 x 1 reports the same outer bake relay shorted, meaning stuck on. This code reports it open, meaning it will not close. This detail speeds up the visit.

Can I bake at a higher setting to compensate?

No. A higher setting will not close an open relay and the oven may still stay cold. Leave it and call us. We note it on your work order.