Wolf Legacy E Series Code Error 07 x 6: left convect fan triac shorted

What Error 07 x 6 means

On Wolf Legacy E Series wall ovens such as the SO30PE/S/PH and DO30TE/S/TH, Error 07 x 6 means the control reads the left convect fan triac as shorted. The x is the cavity digit. In plain words, the switch looks closed or stuck on when the control wants it off. The code shows on the display and the oven may stop that function until the condition is cleared.

Common causes of Error 07 x 6

The left convect fan triac output on the control board staying closed after the command ends
A bad connection on the harness running to the fan motor

✓ One safe check you can try

1. Turn the oven off and wait until the cavity is cool to the touch. 2. Close the door firmly and wipe any debris from its seal. 3. Reset power at the breaker after a one-minute pause. 4. Try a short preheat and note whether Error 07 x 6 shows again. 5. A repeat means the circuit needs testing, so stop using the oven and call us.

! Why to stop there

A reading on the left convect fan triac can come from the board, the harness or the load, and only measuring separates them.
Running the oven again and again with Error 07 x 6 showing can stress other parts of the control.
Once the cause is confirmed, you see the price in writing and decide whether we go ahead.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 1B21Wolf M Series Code 1B21: Cooling fan triac shorted (1B21) 3521Wolf M Series Code 3521: Upper door open or unlocked in clean 1C21Wolf M Series Code 1C21: Both upper bake element DLbs open

Error 07 x 6Error 07 x 6 questions

What is Error 07 x 6 telling me?

It is a status from the control about the left convect fan triac, which it reads as shorted. The x refers to the cavity involved. It does not say the whole oven has failed, only that this one circuit needs attention.

Is Error 07 x 6 an emergency?

Not usually, but it is not something to ignore either. Turn the oven off, let it cool, and if the code stays, call us. We would rather diagnose than have you cook through it.

Who should look at Error 07 x 6?

A technician who can read the oven's circuits safely. The left convect fan triac sits behind panels, and opening them is not a homeowner job. We are glad to help and will quote before we start.