Wolf Legacy Induction Code E6: Electrical supply error

What E6 means

Code E6 on a Wolf legacy induction range, for example the IR304TE/S/TH or IR365TE/S/TH, is an electrical supply error. The cooktop is not getting power the way the control expects, so the zones shut off and E6 shows. Owners often notice it after a storm, a tripped breaker, or when another large appliance on the same circuit starts up. The display stays on E6 until the supply is steady again.

Common causes of E6

Supply voltage at the range outside what the cooktop accepts
Loose or damaged connection at the range power terminals
Breaker or wiring that sags under load
Power input section of the induction electronics

✓ One safe check you can try

1. Turn all zones off. 2. Check your electrical panel for a tripped or half-tripped breaker for the range and reset it fully. 3. Wait two minutes and try a low setting. 4. Do not open the range or touch the power connection yourself. If E6 returns, leave it off and call us, because supply problems can be dangerous.

! Why to stop there

Electrical supply problems can overheat wiring if ignored
The cause may be in the house wiring, not the range
We check the connection and the supply before touching the cooktop
A written price comes first and our work carries a 30-day warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

0221Wolf Dual Fuel DFxx50 Code 0221: Bake element DLB relay shorted, right or single oven Ignition LockoutWolf Gas Burner Code Ignition Lockout: Slow-Blinking Call-for-Heat Light 0222Wolf Dual Fuel DFxx50 Code 0222: Bake element DLB relay shorted, left oven LOWER RELAYWolf Legacy Dual Fuel Range Message LOWER RELAY: Shift Register Feedback Failure OPPWolf Legacy Dual Fuel Range Code OPP: Other Oven Locked for Self-Clean PFWolf Legacy Dual Fuel Range Code PF: Power Failure or Too Hot for Mode 01Wolf Legacy Dual Fuel Range Code ERR 01: Door Lock Switches Not Sensed O9Wolf Legacy Dual Fuel Range Code O9: meat probe shorted

E6E6 questions

Why do I see E6 after a power outage?

Outages and surges can leave the supply at the range unstable. E6 tells you the cooktop saw a problem with the incoming power. Try one full breaker reset, and call us if it returns.

Is E6 a problem with my house wiring?

It can be. The code only says the supply is wrong, not where. We check the range connection and the incoming power so you know whether it is the cooktop or the circuit.

Can I keep cooking with E6 showing?

No. The cooktop is blocking heat on purpose. Pushing past an electrical supply error is not safe, so leave it off until it is checked.