Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Wolf specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 322-7460 Schedule an Appointment
Model library · Wolf Rangetop

SRT366

Wolf SRT366 36-inch Rangetop Repair

Most common issues on this model

  1. Sparking that continues with the burner already lit
  2. Flame height is uneven around the burner
  3. A knob that spins freely with no gas flow
  4. Smell of gas near the top that does not fade, which we handle as a safety call

The SRT366 is built into the counter instead of sitting on an oven, so it often shares its run with a vent hood above and cabinets below. Since it was built 2006–present, we expect some wear at the igniters and valves and plan the visit around that.

All six burners sit on one counter-mounted top with no grill or griddle section to share heat or gas, so we can check each burner one by one. A simmer that will not hold is usually a mix of port blockage and valve wear, and we look at both before replacing anything. A stacked burner has two tiers working together, and we check that both light and settle evenly.

We start by watching each burner light, then shut the gas off at the valve before we take anything apart. Expect a written price up front and a 30-day workmanship warranty on the repair we complete.

Key features

  • 36-inch rangetop with sealed burners: six open burners
  • Sealed burners with a dual-stacked layout for low and high heat
  • Counter-mounted with no oven cavity, so no door lock or self-clean cycle to fail
→Codes

Error codes this model can show

SRT366SRT366 questions
Can one dead burner on my SRT366 be repaired without replacing the whole top?

Usually the trouble is limited to that burner's ignition, valve or knob, so we repair or replace only what is needed. We inspect first, then give you a written price, and our work carries a 30-day workmanship warranty.

Do you test every burner on the SRT366 or only the broken one?

All of them. A problem at one burner can hint at wear elsewhere on the top, so we run each burner through ignition and low flame before we finish. Only needed work goes on the written price.

Is constant clicking at a burner on the SRT366 dangerous?

Continuous clicking is rarely dangerous by itself, but it means the ignition is not settling. Turn the knob off and let us look; we quote any repair in writing before starting.

Book a visit

Book repair for your SRT366

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Schedule an Appointment