Wolf CSOP Plumbed Steam Oven Code F24: Drain sump level sensor

What F24 means

F24 applies to the plumbed Wolf steam ovens CSOP2450TM and CSOP3050TM and stands for E78. The official meaning is that the drain sump level sensor is dirty or has a short circuit. Owners see F24 and the oven stops steam operation, because it cannot read the water level in the drain sump. The first recommended step is to flush the drain with plenty of water.

Common causes of F24

Drain sump level sensor pin dirty
Short circuit in the sensor or sensor module

✓ One safe check you can try

1. Let the oven cool. 2. Pour plenty of fresh water into the cavity drain area, as the guide describes, to flush it. 3. Wipe visible residue from the cavity floor. 4. Switch off at the breaker for one minute and back on. 5. If F24 returns, call us.

! Why to stop there

The sensor pin and module are inside the oven.
A short circuit needs electrical testing.
Residue returns if the drain is partly blocked.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Steam Oven codes

F9Wolf CSO Steam Oven Code F9: cooking space not sealed U0Wolf CSO Steam Oven Code U0: neutral or overvoltage problem U1Wolf CSO Steam Oven Code U1: L2 supply problem U2Wolf CSO Steam Oven Code U2: mains undervoltage Boiler scaled upWolf Convection Steam Oven Message Boiler scaled up: Descale required E26Wolf Convection Steam Oven Code E26: Climate sensor problem E87Wolf 24-Inch E Series Code E87: Exhaust slide valve jammed or shorted E42Wolf Convection Steam Oven Code E42: Water temperature sensor error

F24F24 questions

Which ovens show F24?

The plumbed CSOP2450TM and CSOP3050TM. They have a drain sump with a level sensor, and F24 points to it. On site we look at drain sump level sensor pin dirty and short circuit in the sensor or sensor module, then quote the repair in writing.

Are F24 and E78 connected?

Yes, it is the F label for the E78 condition, and the checks are the same. Starting point for us is usually drain sump level sensor pin dirty, with the price written down before any work.

When should I call?

If a flush does not clear it, call us. We test the sensor and module and quote the repair in writing first. We would also rule out short circuit in the sensor or sensor module before recommending anything.