Wolf Legacy Induction Range Code 39: Controller options error

What 39 means

On pre-2018 Wolf induction ranges such as the IR304TE/S/TH and IR365PE/S/PH, code 39 is a controller options error. The control's option settings, which describe the features and size of your range, are missing or do not make sense. The display shows 39 and the range may not heat. It points to stored setup data, not to cookware or the glass.

Common causes of 39

Option data in the control that is missing or corrupted
Control board that was swapped without being set up for the model
Memory in the control that no longer holds its setup

✓ One safe check you can try

1. Turn off all elements. 2. Leave the breaker off for a full minute before turning it on. 3. See whether the display starts without 39. 4. If 39 stays, do not keep resetting. Stop using the range and call us. 5. Note what the display showed and when it began, then give us a call.

! Why to stop there

Option settings are written with service tools, so owners cannot repair this.
Repeated resets cannot restore lost setup data.
We give a written price before work begins and a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

0022Wolf Dual Fuel DFxx50 Code 0022: Left oven bake element drive shorted 20Wolf Legacy Induction Range Code 20: Input Voltage Over 300 Volts 0121Wolf Dual Fuel DFxx50 Code 0121: Right convection drive shorted in the right oven E01Wolf IR30450 and IR36550 Induction Range Code E01: Left Key Error 0122Wolf Dual Fuel DFxx50 Code 0122: Right convection drive shorted in the left oven ErrWolf Legacy Dual Fuel Range Code Err: How the Error Display Works 0221Wolf Dual Fuel DFxx50 Code 0221: Bake element DLB relay shorted, right or single oven Ignition LockoutWolf Gas Burner Code Ignition Lockout: Slow-Blinking Call-for-Heat Light

3939 questions

What is a controller options error?

Code 39 says the control's option settings are not valid. These settings tell the range which features it has. When they are wrong or missing, the control stops normal operation.

How is 39 different from 31?

Code 31 is an invalid configuration, while 39 specifically points to the controller options. Both are setup-data conditions that need a technician, and we sort out which applies on site.

Is 39 expensive to fix?

It depends on whether the setup can be rewritten or the control must be replaced. We confirm the cause first and give you a written price before any work.