Wolf Legacy E Series Code Error 13 0 0: UIM ambient overtemp error

What Error 13 0 0 means

On Wolf Legacy E Series wall ovens such as the SO30TE/S/TH and DO30PE/S/PH, Error 13 0 0 is a UIM ambient overtemp error. The UIM, the user interface module behind the display, measured a temperature around itself that is above its limit. The oven stops heating to protect the electronics, and the display shows the code. The cavity temperature is not what this code measures, so cool the area behind the display.

Common causes of Error 13 0 0

Heat building up around the UIM behind the display
Blocked airflow or poor ventilation around the oven
A UIM temperature reading that stays too high

✓ One safe check you can try

1. Turn the oven off and let it cool for an hour or more. 2. Clear the vents and the space around the oven. 3. Check that the kitchen is not unusually hot. 4. Switch the breaker off for one minute and on again. 5. If Error 13 0 0 returns once cool, stop using the oven and call us.

! Why to stop there

The display electronics are sensitive to heat, so we find the source before it damages them.
A reading that stays high in a cool room points to a sensor or board problem needing a test.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 1B21Wolf M Series Code 1B21: Cooling fan triac shorted (1B21) 3521Wolf M Series Code 3521: Upper door open or unlocked in clean 1C21Wolf M Series Code 1C21: Both upper bake element DLbs open

Error 13 0 0Error 13 0 0 questions

What is Error 13 0 0?

The UIM measured an ambient temperature above its limit. In other words, the area around the display electronics is too hot. It protects the display electronics from heat and stops heating when needed.

How is it different from Error 12 0 0?

12 0 0 is the relay module reading too hot. 13 0 0 is the user interface module reading too hot. They protect different parts of the control.

Will it clear after cooling down?

Often it does if the cause was heat or blocked airflow. If it returns when the oven is cool, book a visit. We give a written price first.