Wolf Legacy E Series Code Error 07 x 17: Right convection relay open

What Error 07 x 17 means

Wolf Legacy E Series wall ovens such as the DO30TE/S/TH display Error 07 x 17 when the right convection relay is open. The control calls for the right convection element, the relay does not close, and the element gets no power. Convection results are uneven, and the code stays on the display. Remember that x is the cavity digit, not a letter you will see on screen.

Common causes of Error 07 x 17

Right convection relay not closing
Relay board output damaged
Wire or connector to the right convection circuit loose

✓ One safe check you can try

1. Select off, then give the oven a good cool-down period. 2. Try a regular bake instead of convection. 3. At the panel, shut off the oven breaker for 60 seconds, then restore it. 4. If Error 07 x 17 reappears, stop using the oven and book us.

! Why to stop there

The relay board is behind panels near line voltage.
We must tell a bad relay from a bad element or connector with meter tests.
We quote in writing before any repair.
You also get a 30-day warranty on how the repair was done.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 1831Wolf M Series Code 1831: Upper door lock relay open 3311Wolf M Series Code 3311: Upper thermal cutoff open 1A31Wolf M Series Code 1A31: Upper left convection fan triac open

Error 07 x 17Error 07 x 17 questions

Does the code name the element or the relay?

It names the relay. The right-hand element reports separately through Error 03 x 4, so a technician reads both codes together for the full picture.

Why is food cooking unevenly?

With only one side of the convection heating powered, the air in the cavity heats unevenly, which shows up on the food as hot and cool spots.

Is it urgent?

It is not a safety alert like a stuck relay, but ongoing use can strain the other circuits. We suggest booking a visit soon. That is why we measure first.