Wolf M Series Wall Oven Code 4231: Upper broil element not detected

What 4231 means

Wolf M Series wall ovens such as the SO3050TM/S/T report 4231 when the upper broil element is not detected. The control sends power to the element and sees no current return, so it treats the element as missing. You will see 4231 on the display. Broil may stay cold, and browning or toasting takes far longer than usual. The lower cavity of a double oven is covered by its own code.

Common causes of 4231

Open or burned-out upper broil element
Loose terminal or connector at the upper broil element
Relay board output feeding the upper broil element
Wiring between the relay board and the broil circuit

✓ One safe check you can try

1. Clear the oven of food, turn it off, and let it rest until cool. 2. Interrupt the oven's power at the breaker for two minutes, then resume. 3. Try a short Bake and check for 4231 on the display. 4. If it comes back, skip those modes and book a visit. The element terminals are behind panels and should not be touched.

! Why to stop there

Heating loads draw heavy current, and a hot, loose terminal is a real hazard for anyone without a meter and training.
A reading across the upper broil element tells us in minutes what guessing cannot.
Before we pick up a tool you get the price in writing, and the repair is warranted for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0121Wolf M Series Oven Code 0121: upper right convection relay shorted 0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 2420Wolf M Series Code 2420: Relay board RTD circuit 3C20Wolf M Series Code 3C20: High input voltage 2631Wolf M Series Code 2631: Relay board door switch circuit

42314231 questions

Why does the oven say the upper broil element is missing?

It sends power to the element and looks for the electrical load that should follow. When nothing shows up, the control reports the element as absent, even if it is physically in place.

Is it safe to keep trying broil?

If broil still heats normally, light use is usually fine. Stop if you smell burning or see sparks, and shut the breaker off. A dead element is rarely dangerous, but a hot connection can be.

What will you do when you arrive?

We check the element's resistance, inspect its terminals for heat marks, and confirm the relay board is sending power. Then we explain what failed and give a written quote.