Wolf Microwave Drawer ERROR After 16 Seconds: AH Sensor

What ERROR (after 16 s) means

On Wolf microwave drawers such as the MD24TE/S, MD30PE/S and MD30TE/S, plus the MWD24 and MWD30 series, ERROR appearing 16 seconds after you press start points to the AH sensor. The drawer runs briefly, then stops and shows ERROR. Owners notice the timing: it happens every cycle at about the same moment, even with a simple cup of water. We match it to your exact model, which is why a visit starts with a check.

Common causes of ERROR (after 16 s)

AH sensor not reading properly
Sensor connection interrupted
Control board not receiving the sensor signal

✓ One safe check you can try

1. Open the drawer and remove anything blocking the cavity or vents. 2. Wipe moisture and food splatter from the cavity and drawer seal. 3. Try a short run with a cup of water in a microwave-safe bowl. 4. Switch the breaker off for a minute and on again. If ERROR repeats at 16 seconds, call us.

! Why to stop there

The repeating 16-second timing tells us to test the AH sensor path, which owners cannot reach safely.
Microwave interiors hold a stored high-voltage charge, so we advise no panel removal.
Thirty days of workmanship coverage apply to the finished repair.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Microwave codes

iWolf MDD Information Cue i: Press Settings for Tips and Weight Range AH SensorWolf Microwave Drawer Code AH Sensor: stops after 16 seconds with ERROR DoorWolf Microwave Drawer Code Door: Drawer Will Not Open or Close Fire SenseWolf Convection Microwave Code Fire Sense: Fire Detected, Shutdown Monitor SwitchWolf Microwave Drawer Code Monitor Switch: Monitor Fuse Blown at Plug-In No-HeatWolf Drop-Down Door Microwave Code No-Heat: door not latching TCOWolf Microwave Code TCO: thermal cutout open, unit dead Error (after 10-20 s)Wolf MDD Microwave Error After 10 to 20 Seconds: AH Sensor Check

ERROR (after 16 s)ERROR (after 16 s) questions

Why does my microwave drawer stop at 16 seconds?

On MD and MWD drawers, ERROR after 16 seconds points to the AH sensor. The drawer starts normally, then the control stops the cycle when the sensor reading is not accepted.

Does a breaker reset help?

It can clear a one-time glitch. If ERROR returns at the same 16-second mark, the sensor circuit needs testing and a reset will not repair it.

Is this safe to leave unrepaired?

The drawer stops itself, so it is not heating unchecked. Still, avoid repeated attempts. Call us and we will test the sensor and quote the repair in writing.