Wolf Legacy E Series Code Self-Clean Rate-of-Rise Error: 14 x 0 during cleaning

What Self-clean rate-of rise error means

On Wolf Legacy E Series wall ovens from the SO30TE/PE generation, code 14 x 0 is the self-clean rate-of-rise error. During cleaning, the oven temperature climbed at an unexpected rate. The instructions are to check the oven for leaks and insulation problems and to run diagnostics for open outputs or loads. You will see the cycle stop partway with the message.

Common causes of Self-clean rate-of rise error

Air leak around the door or cavity
Insulation problem letting heat behave abnormally
Open output or load detected in diagnostics

✓ One safe check you can try

1. Let the oven cool completely. 2. Check the door gasket area and wipe it clean. 3. Clear the cavity of racks, foil and heavy soil. 4. Do not start another clean cycle; use a normal bake to check heating and call us if 14 x 0 returns.

! Why to stop there

Leaks and insulation problems cannot be judged from the outside.
Diagnostic runs for open outputs use the control's own test modes.
We quote in writing first and stand behind our work for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

0221Wolf M Series Code 0221: Upper Bake Element DLB Shorted 0321Wolf M Series Oven Code 0321: Broil Relay Shorted on the Upper Element 0421Wolf M Series Code 0421: upper left convection relay shorted 0630Wolf M Series Oven Code 0630: Auxiliary DLB Shorted 0121Wolf M Series Oven Code 0121: upper right convection relay shorted 1231Wolf M Series Code 1231: Upper bake element DLB open 2C20Wolf M Series Code 2C20: Relay board network failure 1321Wolf M Series Code 1321: Upper broil element relay open

Self-clean rate-of rise errorSelf-clean rate-of rise error questions

What is a rate-of-rise error?

During self-clean the oven expects temperature to climb at a certain pace. If it rises faster or slower than expected, as flagged by 14 x 0, the cycle stops.

Is heavy soil the cause?

Heavy soil can affect cleaning, but this code points to leaks, insulation or open outputs. Remove loose debris, then call us if the code returns.

Can I run self-clean again?

We would wait. Repeating a clean cycle with a leak or output problem can overheat the surroundings. Use normal baking until we check the oven.