Wolf Legacy Dual Fuel Range Message CONTROL COM: Flat flex cable or controller

What CONTROL COM means

On legacy Wolf DF dual fuel ranges that show text messages, CONTROL COM means communication was lost with the oven controller, and the flat flex cable or the controller itself is the likely cause. The flat flex cable carries signals between the display and the controller. You will see CONTROL COM, and keys and heating may stop responding. Tell us what the display shows and when CONTROL COM started, so we arrive prepared.

Common causes of CONTROL COM

Flat flex cable between the display and controller that is loose or damaged
Oven controller that is not answering
Display board that cannot read the link

✓ One safe check you can try

1. Turn off the oven. 2. Shut the range breaker off, pause a minute, and turn it on once more. 3. Wait for the display to start and watch for the message. 4. If CONTROL COM returns, stop and call us. Do not touch the cable or open the panel.

! Why to stop there

The flat flex cable is delicate, and handling it wrongly can cause new damage.
We test both ends of the link before ordering anything.
You get a written price first, and a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

03ERR 03 on a Wolf Legacy Dual Fuel Range: Open Circuit on the RTD Oven Sensor OEWolf Legacy Dual Fuel Range Code OE: power relay shorted CFH light slow blinkWolf DSI Gas Burner Code CFH Light Slow Blink: Ignition lockout 04Wolf Legacy Dual Fuel Range ERR 04 Code: Shorted RTD Sensor Circuit E05Wolf Induction Range Cooktop Code E05: LIN communication, no generator response 07ERR 07 on a Wolf Legacy Dual Fuel Range: Control Head Communication Lost E07Wolf Induction Range Cooktop Code E07: Primary control too hot 08Wolf Legacy Dual Fuel Range ERR 08 Code: EEPROM Checksum Wrong at Power-Up

CONTROL COMCONTROL COM questions

What is the flat flex cable?

It is a thin ribbon cable carrying signals between the display and the oven controller. If it loosens or cracks, the oven stops communicating, and CONTROL COM appears.

Is it the cable or the controller?

Either one can cause it. We check the cable first because it is the simpler repair, then the controller. A short description of what you saw helps, so there is no surprise charge afterward.

Can I plug it back in myself?

We advise against it. The panel is behind live wiring. Call us for a written price. We note your model and the exact display, so nothing is replaced without your approval.