Wolf WWD30 Warming Drawer Code 60: Stuck Relay and Overheating

What 60 means

On Wolf WWD30 and WD30 warming drawers, code 60 reports a stuck relay. The drawer temperature climbs to 250F in any mode, because the relay keeps power on to the element. Notes say strong outdoor sun can trigger it. The owner sees 60 and the drawer may be hotter than its setting, which can be unsafe for food and the cabinet.

Common causes of 60

Stuck relay keeping the element powered
Strong outdoor sun heating the drawer area
Control board relay problem

✓ One safe check you can try

1. First press Power On/Off to stop heating. 2. Switch off the drawer breaker and leave it off. 3. Let the drawer cool, then carefully remove any food. 4. If direct sun hits the unit, shade it and try again later. 5. If code 60 returns, keep the breaker off and call us.

! Why to stop there

A stuck relay can overheat the drawer in any mode, so we do not recommend using it.
Relays sit with the control electronics, which are not an owner area.
We confirm the cause, quote in writing before work, and give a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Warming Drawer codes

PFWolf Warming Drawer Code PF: Power Failure Notice 30Wolf Warming Drawer, Code 30: Thermistor Short 40Wolf WD30 Warming Drawer Code 40: Element Sensing Error During Preheat 50Wolf WWD30 Warming Drawer Code 50 (Door Switch): Closed During Operation 70Wolf Warming Drawer Code 70 (Cable): Relay Link to Control Open Er3Wolf CW24 Cup Warming Drawer Code Er3: Temperature Sensor Open FUSEWolf Warming Drawer FUSE Message: Beeping, Control Board Needed HOTWolf Warming Drawer HOT Message: Temperature Above Setting

6060 questions

Why is the drawer hot when set low?

With a stuck relay, power stays on to the element, so the temperature rises toward 250F regardless of mode. That is why we advise shutting off the breaker.

Can the sun really cause code 60?

Notes say outdoor sun can trigger it. If sun hits the unit, shade it and watch for a repeat. If it returns in the shade, treat it as a relay problem.

Is it safe to leave it powered?

Switch the breaker off until we inspect it. A drawer that keeps heating on its own is a risk to food and cabinets, and we quote the repair in writing first.