Wolf CSO Steam Oven Code F29: Door lock not initialized or motor short

What F29 means

F29 on Wolf CSO convection steam ovens, including the CSO24 and CSO30 series, covers the E115, E117 and E118 door lock codes. The official meaning is that the door lock did not initialize, or there is a short circuit in the door-lock motor circuit. Owners see F29 and the door may stay locked or the oven will not start. It is an electrical code, so it needs a technician.

Common causes of F29

Door lock not initialized
Short circuit in the door-lock motor circuit

✓ One safe check you can try

1. Make sure the door is fully closed and nothing is caught in it. 2. Switch the breaker off for one minute, then restore power so the lock can try to initialize. 3. If F29 returns, do not force the door. 4. Call us. Do not open the casing or touch the lock.

! Why to stop there

A shorted motor circuit is an electrical hazard to test.
Forcing a locked door can break the latch.
The lock sits inside the door and frame.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Steam Oven codes

U1Wolf CSO Steam Oven Code U1: L2 supply problem U2Wolf CSO Steam Oven Code U2: mains undervoltage Boiler scaled upWolf Convection Steam Oven Message Boiler scaled up: Descale required E26Wolf Convection Steam Oven Code E26: Climate sensor problem E87Wolf 24-Inch E Series Code E87: Exhaust slide valve jammed or shorted E42Wolf Convection Steam Oven Code E42: Water temperature sensor error E26Wolf 24-inch E Series Code E26: Break or loose contact in climate sensor, or blocked duct E87Wolf Convection Steam Oven Code E87: Exhaust slide valve stuck

F29F29 questions

What are E115, E117 and E118?

They are the door lock codes behind F29. They mean the lock did not initialize or its motor circuit has a short. On site we look at door lock not initialized and short circuit in the door-lock motor circuit, then quote the repair in writing.

Can I open the door by force?

Please do not. Forcing it can damage the latch. If it is stuck, call us and we will release and repair it. Starting point for us is usually door lock not initialized, with the price written down before any work.

Will a reset help?

Once, yes. A reset lets the lock try to initialize again. If F29 comes back, we test the lock motor and circuit. We would also rule out short circuit in the door-lock motor circuit before recommending anything.